Sig P365, Sig Romeo Zero

Temporarily not available while we are moving!
No reviews yet Write a Review

This will mill the Sig P365 for the Sig Romeo Zero red dot. It will leave the rear dovetail untouched, and sit the red dot low enough that it should cowitness with a Dawson .205" tall front sight, pictured here. When done, the red dot will cover the extractor pivot pin, so you will not be able to remove your extractor without removing the red dot first, and you may also need to shorten your extractor pivot pin. The holes will be cut M4-0.7 for the screws included with your red dot, some fitting for length may be required if you are installing the red dot yourself.

Please Note: Recoil lugs will be machined in the rear of the cut, rather than the front as shown here, so that it can accommodate the Romeo Zero Shroud, which only has holes cut in the rear. Otherwise, the milling is identical to what is pictured here.