7 of 7 Items
  • RMSC to 407/507k footprint Modification

    RMSC to 407/507k footprint Modification

    Factory milled RMSC footprint converted to 407/507k footprint by lowering front studs and removing rear studs. This allows you to directly mount your 407/507k rather than using an adapter plate. Slide refinishing required.     Models:...

    $75.00
  • Sig P365, Sig Romeo Zero Sig P365, Sig Romeo Zero

    Sig P365, Sig Romeo Zero

    This will mill the Sig P365 for the Sig Romeo Zero red dot. It will leave the rear dovetail untouched, and sit the red dot low enough that it should cowitness with a Dawson .205" tall front sight, pictured here. When done, the red dot will cover the...

    $125.00
  • Sig P320, Sig Romeo Zero Sig P320, Sig Romeo Zero

    Sig P320, Sig Romeo Zero

    This will allow you to mount your Sig Romeo Zero red dot directly on your Sig P320 slide. This program will leave the factory rear dovetail intact, and will machine the red dot deep enough that the integral iron sight on the Romeo will cowitness with the...

    $125.00
  • Sig P365, Trijicon RMRcc

    Sig P365, Trijicon RMRcc

    This will allow you to mount the Trijicon RMRcc on your Sig P365 without any mounting plates. This program allows you to keep your factory rear dovetail, so you can cowitness with iron sighs. The top of the red dot base is roughly .225" above the top of...

    $125.00
  • Sig P365, Holosun 407k/507k Sig P365, Holosun 407k/507k Sig P365, Holosun 407k/507k

    Sig P365, Holosun 407k/507k

    This will allow you to mount your Holosun 507K red dot directly to your Sig P365 slide. This will keep your rear dovetail intact, allowing you to cowitness with iron sights. The top of the base on this red dot is .140" above the top of the slide, so you...

    $125.00
  • Sig P320, Leupold Delta Point Pro Milling

    Sig P320, Leupold Delta Point Pro Milling

    This will allow you to mount your Leupold Delta Point Pro directly to your Sig P320 slide. This will leave the rear dovetail, so you can can cowitness iron sights, but the DPP is relatively tall and the P320 slide does not allow us to machine very deep...

    $125.00
  • Sig P320, Trijicon RMR, Optic Milling Sig P320, Trijicon RMR, Optic Milling Norssco Slide milled for a RMR with a Multicam Cerakote job Sig P320, Trijicon RMR, Optic Milling

    Sig P320, Trijicon RMR, Optic Milling

    This will allow you to mount your Trijicon RMR red dot directly to your Sig P320 slide. It will leave your rear dovetail untouched, so you can cowitness with iron sights if you want. The distance from the top of the red dot base to the top of the slide...

    $125.00
7 of 7 Items