Brimstone Custom 10/22 Trigger

This is our billet machined trigger ONLY. Just the trigger. Not a trigger group. Not a trigger job. Just the trigger, our torsion spring, two set screws, and the tools you need to install it. 

Let me repeat. This is just the machined trigger, like in the picture to the. Just so we are all clear. So don't buy this and then complain when ONLY A TRIGGER shows up in the mail. Because I know someone is going to do that... 

Our triggers are available three ways: 

1. The trigger blade only. This trigger blade is a direct replacement for the factory one, and will work just fine with your factory trigger return plunger. However, it will ONLY be a cosmetic upgrade; you should not expect any improvement in trigger feel or function over the factory. I mean, yes of course this trigger will feel different under your finger, but it will not in any way change the trigger pull. 

2. The trigger blade with our torsion trigger return spring, and the two set screws required for it to work. This trigger has been machined to accept the torsion trigger return spring. Two holes will need to be drilled and tapped (please see the Brimstone Trigger Kit Guide here for more information before buying), one which will hold the other end of the torsion spring, and a second which will go in the factory trigger return spring hole, and act as a very clean and inconspicuous overtravel stop. 

3. The trigger blade, torsion spring and set screws, and the #29 drill and 10-32 tap needed to install it. If you don't already have these tools, here you go. I would also suggest that you should probably have a drill press, a small file, and a tap handle if you are going to install the kit. It is NOT drop in, but it is one of the best/cleanest set-ups out there when installed with care. 

This will ONLY work with the factory 10/22 trigger groups! In case you've been living under a rock in the 10/22 world, you're aware that Ruger and other companies (such as Thompson Center, Volquartsen, etc.) are making other trigger groups which claim to be compatible with the Ruger 10/22. And while that is true, that does not mean our trigger will work in their trigger groups. This will ONLY work in standard trigger groups, either older aluminum or newer polymer. This is NOT compatible with BX internals, and we do not make any claims as far as compatibility with any other companies internals.  

Again, the trigger blade alone will only be a cosmetic upgrade, really. The trigger with our torsion spring will usually greatly assist in cleaning up the trigger movement, dialing out the over travel and making the 'stages' in the trigger press much more noticeable. 

THESE ARE NOT DROP IN! They will require some fitting, and if you elect to get the (awesome) trigger return spring kit, that will require permanent modification to your trigger housing. Read the directions below, and make sure that you are comfortable with the work before you order the parts. 

(We are working on a video for installing these triggers, but until then all we have is this write up. If you're just buying the trigger, the Brimstone Trigger Fitting Guide is all you'll need. If you're buying the full trigger Kit, you'll ALSO need the Brimstone Trigger Kit Installation Guide)